| Protostar Flash |
|
 |
| • |
The all-new end face geometry enables significantly higher tooth feed rates fz for faster material removal rates |
| • |
High-quality TiAlN coating for maximum tool life |
| • |
Since cutting takes place exclusively on the end face of the tool, the machine spindle is subjected almost only to axial forces that are easily absorbed |
|
| Protostar Qmax |
 |
| • |
Solid carbide milling cutter with knurled splines reduces cutting forces and generates short chips |
| • |
Internal cooling aids chip removal and increases process reliability |
| • |
Very good roughed surface due to improved roughing profile |
| • |
All tools have the latest TiAlN coating offering advantages for dry and wet machining |
|
| Tough Guys |
 |
| • |
Roughing and finish-cutting without a tool change |
| • |
High material removal rate with best tool stability through different depths of flute with large chip space |
| • |
Up to double the feed rate is possible in comparison to standard tools |
| • |
Uneven cutting edge pitch produces smooth milling characteristics and low-vibration machining
No chatter marks |
|
| Ultra – shank cutter with corner radius |
 |
| • |
Machining of hardened steels up to 65 HRC |
| • |
Very stable wedge due to negative rake angles for maximum tool life |
| • |
Increase in the material removal rate due to HPC strategies, e.g. slot milling by means of toroidal milling cutters |
| • |
Very good surface quality, even in the finishing of blind hole surfaces |
|
| Ultra – radius cutter with 3 centre-facing cutting edges |
 |
| • |
Machining of hardened steels up to 65 HRC |
| • |
Increase in productivity when finishing due to the use of 3 effective cutting edges |
| • |
Best surface finish in 3-axis and 5-axis machining |
|
| HSC30 |
 |
| • |
Increase in productivity due to HSC application |
| • |
Special diamond coating for maximum tool life in graphite |
| • |
Tools with minute diameters, specifically for machining lattice electrodes |
| • |
Due to neck-free finish, projection lengths of up to 20 x d1 are possible |
|
